Ed Essex

Ed Essex

Tuesday, 30 April 2013 00:00

Foundation No No

This blog is about one of the challenges you will face when you start your new home or addition. It’s also about one of the biggest mistakes made by seasoned builders as well as “do it yourselfers”. It has to do with your foundation and what you are going to put it on.

We’ve all heard the old cliches about cornerstones and foundations being the most important key to a successful build. I won’t re-hash those here. We all know it to be true.

One of the most common mistakes made in foundation work is to putting the foundation on unacceptable ground or fill.

I was asked once to build a concrete foundation for a house on crappy fill dirt. The property was sloped. The contractor had cut into the slope and then used that cut fill to level a building spot. Cut and fill to balance a site is okay, we did some of that here, but not if the fill is non compactable or unacceptable to carry a load without future settling. I refused to do the job because eventually that foundation was going to fail. One half of it was on good sub grade but the other half was going to be on poor load carrying topsoil. Where the two type soils meet there was going to be a break in the concrete foundation and settlement of one half of the house.

I have been hired to repair this exact type of damage. One half of the house settles and the other half stays where it should. First we had to jack the sagging half of the house back up to level. Then we had to go under the sagging foundation and dig down until we hit good soil and put new foundation piers in to hold it up. It was very expensive and entirely avoidable.

In our case on our homestead, we were somewhat horrified to find that our topsoil was 4’ deep in the location we wanted to build. Most of our acreage has topsoil that averages 14” deep. It cost us more excavation money to move the topsoil off the building site but it had to be done. We had to get down to the native clay/gravel mixture you find here that is suitable to build on. We had to completely change our plans for grades around our home but again, it had to be done. It cost more than I had budgeted but not near as much as it would have if we had ignored the problem. We ended up with a completely different “look” of the grades around our house but it’s what we had to do.

I would guess most of these decisions are about money. Sometimes it just costs more up front to do it right but I can guarantee you it will be less expensive in the long run. It always costs more to come back and do a job in a “finished” environment. In the above example of the home repair, we didn’t have access for equipment due to property lines and existing landscaping etc. Everything had to be done by hand and it took several weeks. The homeowners had to access their house through mud and over ditches. It was no fun for them; let alone what they had to pay for it.

I was talking to my neighbor this past weekend and he was sharing a story about his pole barn he built at his last residence. He had the excavator on site three times longer than he had anticipated because they ran into poor soils. He had to bring in 15 truckloads (150 cubic yards @ $15.00) of good fill to build on after the garbage dirt (also 159 cubic yards) had been hauled away. He did exactly what he was supposed to do.

You can build the best foundation in the world but if it isn’t sitting on good soil it will fail. Click on this Illustration (PDF) to see a picture of a proper cut and fill job. This plan was drawn by a civil engineer for our home which was built on a slope. Notice the tiered “cuts” that were made to accommodate the approved fill. You never want to put good fill on a slope.

Ed and Laurie Essex live off grid in the Okanogan Highlands of Washington State where they operate their website goodideasforlife.com and Off Grid Works.

Page 9 of 9

Featured

  • Our Home Design Features Part 1

    Our off grid home has many design features you don’t normally find in most houses. Many people come here to see what some of these features look like or how they operate. Since I seem to struggle with my memory more and more I thought it would be nice to list them out along with a little explanation of them. Most of them are explained in detail on prior Blogs. Roof overhangs – our eave length is calculated to keep the sun out of the windows in the summer which helps with natural cooling, and let the sun in during Read More
  • Our Home Design Features Part 2

    Our off grid home has many design features you don’t normally find in most houses. Many people come here to see what some of these features look like or how they operate. This is the second installment of features. Part 1 was published last week. See Part 1 Insulated cold frames – on the south side of the house we put in raised bed insulated cold frames. We have grown fresh cold weather type vegetables as cold as 18F with nothing to heat them but the sun. They are attached to the side of the house which never freezes. Plug Read More
  • I Built My House for Extreme Weather

    I went to work in the family commercial construction company in the early 1980's and by the end of the decade had worked my way into the office as a project manager. Commercial construction is entirely different than residential construction. For one thing, everything is engineered - structural, mechanical, and electrical engineers all take a part in the design of commercial buildings. It wasn't long before I discovered the term "100 year storm". Many structural designs and mechanical designs were based on the 100 year storm (I'm over simplifying for the purpose of this article). Things like concrete foundation design and Read More
  • 1