Friday, 06 February 2015 00:00

Home Generator Repair

off grid, homestead, good ideas for life, generator repairGenerators are an important aspect of most homesteads and off grid living.  Our smallest generator is a 3500 watt portable unit that we use to top off our batteries or haul around the property for projects that might be a little out of range for our battery operated power tools.

I have no idea how many hours we have on it but it was purchased in 2008 and used extensively to build our house, keep our batteries charged on cloudy days and most importantly to run our 240 volt deep well water pump. The water pump maxed out the generator capacity. This past year it finally gave out and could no longer produce electricity the way it was supposed to. It would work erratically on and off and anywhere from 50% voltage to 100%.

We live over 100 miles (200 miles round trip) from the nearest generator repair shop. By the time you take it there, pay the repair bill, and go back to pick it up you might as well buy a new one with ALL new parts.

I am the least mechanically inclined person I know and electrical is way out of my league but with nothing to lose I decided to do what I could to get this necessary piece of equipment up and running again.

I went online to You Tube and searched for a video that described my generator problems and ended up with a video from the Generator Guru. This video described how to remove the cover plate to expose the electrical wiring and parts that were directly responsible for generating power. It then goes on to lay out a step by step series of tests you can do with a voltage meter or multi meter to diagnose which part is not working properly. It also gives you the voltage parameters you will be looking for on each test.

off grid, homestead, generator repair, generator, good ideas for lifeThese are the steps I took to diagnose my generators problem:

1. Disconnect the AVR (automatic voltage regulator) - this is so you can get raw real voltage data on steps 2-5.
2. Test the voltage for the brushes - this might tell you if you need new brushes or not.
3. Test the voltage on L1 and L2 - these might tell you if you need new windings or not
4. Test the voltage on RI and R2 - these will tell you if the rotor is bad or not.
5. Test L1 and R1 - this test has to do with the 240V option my generator has.

I did my tests and wrote the voltages down for each of the above items and called the National Support Hotline for my brand of generator. I described how the generator was behaving and gave them the voltage test results. (It should be noted that even though some of my results were outside the parameters given in the video it didn't mean those parts were bad - i.e. the video said the voltage for brushes should be between 5v and 10v. Mine was 19v but my support hotline said that was okay for my generator).

The support person immediately diagnosed that the AVR was bad and I needed a new one. I purchased it right there on the phone for $31.00 including shipping. The AVR arrived at the post office box a few days later. It only took about 10 minutes to install and my generator once again performs perfectly. I virtually saved myself the cost of a new generator which would run around $350.00.

I would like to caution you that there are many more things that can go wrong with a generator, including bad spark plugs,  bad outlets, bad switches, and more. This article is not intended to cover all of the bases but it might just be a good place to start. It worked for me and I can guarantee you one thing - if I can do it, so can you.

Ed and Laurie Essex live off grid in the Okanogan Highlands of Washington State where they operate their website  and Off Grid Works.


More in this category: « Insulated Concrete Forms


  • Our Home Design Features Part 1

    Our off grid home has many design features you don’t normally find in most houses. Many people come here to see what some of these features look like or how they operate. Since I seem to struggle with my memory more and more I thought it would be nice to list them out along with a little explanation of them. Most of them are explained in detail on prior Blogs. Roof overhangs – our eave length is calculated to keep the sun out of the windows in the summer which helps with natural cooling, and let the sun in during Read More
  • Our Home Design Features Part 2

    Our off grid home has many design features you don’t normally find in most houses. Many people come here to see what some of these features look like or how they operate. This is the second installment of features. Part 1 was published last week. See Part 1 Insulated cold frames – on the south side of the house we put in raised bed insulated cold frames. We have grown fresh cold weather type vegetables as cold as 18F with nothing to heat them but the sun. They are attached to the side of the house which never freezes. Plug Read More
  • I Built My House for Extreme Weather

    I went to work in the family commercial construction company in the early 1980's and by the end of the decade had worked my way into the office as a project manager. Commercial construction is entirely different than residential construction. For one thing, everything is engineered - structural, mechanical, and electrical engineers all take a part in the design of commercial buildings. It wasn't long before I discovered the term "100 year storm". Many structural designs and mechanical designs were based on the 100 year storm (I'm over simplifying for the purpose of this article). Things like concrete foundation design and Read More
  • 1